Aplication guide

Step One – Clean
Wash your plastics and wipe them with alcohol (isopropyl/denatured). Make sure the surface is dry, clean, and grease-free.

Step Two – Prepare
Cut off a small piece of the backing paper to expose part of the adhesive.

Step Three – Apply
Place the exposed part onto the plastic and press it firmly into position.

Step Four – Smooth
Gradually remove the rest of the backing paper while pushing out bubbles toward the edges (use fingers or a squeegee).

Step Five – Heat
Heat the decal with a hair dryer or heat gun (don’t overheat). This activates the adhesive and helps it stick to curves and edges.

Tip: Tiny bubble? Just pierce it with a needle and press the air out.